Loading the Transfer Ribbon Cassette
Dynacode II Series
42
Operating Manual
08.16
8.2 Transfer Ribbon With Coating Inside
Figure 31
Turn the lever (A) 90° in clockwise direction.
Remove the ribbon cassette from the print mechanics
by pulling handle (B).
Load a new ribbon roll as far as it will go onto the
unwinding roll (C).
Load an empty cardboard roll as far as it will go onto
the rewinding unit (D).
Insert the ribbon according to illustration.
Fix the ribbon with an adhesive tape at the empty roll
and tighten it by some turns of the core.
Push the ribbon cassette again onto print mechanics
and take care that the ribbon not rip.
Turn the lever (A) 90° anticlockwise.
NOTICE!
The above illustration shows a left hand printing system. If you
are using a right hand system, then the new roll is to be
inserted at the left and the cardboard core is to be inserted at
the right side.
