Vario II
English
93
Password protection
Keys:
,
,
,
,
,
,
,
,
,
,
Key:
Password:
By a password several functions can be blocked, so the user cannot work with them.
Service functions
Keys:
,
,
,
,
,
,
,
,
,
,
,
Key:
Label parameters:
Indication of label parameters in Volt.
A:
Indication of minimum value.
B:
Indication of difference between minimum and maximum value.
C:
Indication of trigger level. The value is ascertained while measuring and can be changed.
Key:
Photocell parameters:
TLS:
Indication of transmission photocell level in Volt.
RLS:
Indication of reflexion photocell level in Volt.
SLS:
Indication of peel off photocell level in Volt.
RC:
Indication of transfer ribbon photocell status (either 0 or 1).
H:
Indication of printhead position.
0 = printhead down
1 = printhead up
Key:
Heater resistance:
To achieve a high print quality, the indicated Ohm value must be set after an exchange of
printhead.
Key:
Printhead temperature:
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current
print order is interrupted and an error message appears at the printer display.
Key:
Motor Ramp:
This function is often used for high printing speed as the tearing of transfer ribbon can be
prevented.
The higher the '++' value is set, the slower the feeding motor is accelerated.
The smaller the '
− −' value is set, the faster the feeding motor is decelerated.
Key:
Cutter photocell:
1 - Printer is equiped with a cutter; 0 - Printer is not equiped with a cutter
Cut Home
:
1 - The cutter is in the initial position and ready for the cutting procedure.
0 - The cutter is not in the initial position. Before you are going to release a cutting procedure
you first have to place the cutter in its initial position.
Key:
Online/Offline:
This function is activated e.g. if the transfer ribbon is to be changed. It is avoided that a print
order is processed although the module is not ready. If the function is activated then press
the key
to change between Online and Offline mode. The respective state is indicated in
the display (Standard: Off).
Online:
Data can be received by interface. The keys of the foil keyboard are only active, if
you changed in the Offline mode with key
.
Offline:
The keys of the foil keyboard are still active but received data are not processed. If
the module is again in Online mode then new print orders can be again received.
Summary of Contents for Vario II series
