Vario II
94
English
Key:
Input/Output:
Indication of signal level which indicates the signal a print order is started.
0 - Low
1 – High
Key:
IN signal level:
Indication of signal at which a print order is started.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
x = not activated signal level
s = status can be affected by interface (in combination with Netstar PLUS)
The modification of the signal level is only taken into consideration for the operating modes
I/O static, I/O dynamic, I/O static continuous and I/O dynamic continuous.
Key:
OUT signal level:
Indication of signal level for output signal.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
s = status can be affected by interface (in combination with Netstar PLUS)
Key:
TRB = Transfer ribbon advance warning:
Before the end of transfer ribbon, a signal is send by the control output.
Warning diameter:
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control output when reaching this
diameter (measured at transfer ribbon roll).
v = Reduced print speed:
Setting of the reduced print speed. This can be set in the limits of the normal print speed.
Additionally there are the following settings:
−: No reduced print speed
0
: Printer stops at reaching the warning diameter and indicates 'ribbon error'.
Key:
Port test:
Examination of photocell.
Key:
Hotstart:
On:
Continue an interrupted print order after switching on the printer anew.
(Only if printer is equipped with option Compact Flash card)
Off:
After switching off the printer the complete data is lost.
Key:
Autoload:
On:
A label which was loaded once from the memory card can be loaded again
automatically after a restart of printer.
The last loaded label from memory card is always again loaded after a restart of printer.
Off:
After a restart of printer the last used label must be again loaded manually from the
memory card.
A common use of the functions Autoload and Hotstart is not possible.
Key:
Invert label:
On:
Label is printed inverse.
Off
: Function is deactivated.
Key:
Manual reprint:
Yes:
I In case an error occurred and printer is in stopped mode then you can reprint the last
printed labels by means of keys and
.
No:
Only blank labels were advanced.
Key:
Zero point adjustment:
Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the same position on the
label, the difference can be corrected.
The value for zero point adjustment is set ex works. After replacing the printhead, only
service personnel are allowed to set this value anew.
Summary of Contents for Vario II series
