Vario III Series
Technical Data
11.13 Operating
Manual
19
Figure 3
Identification
Pin
Description / Function
Port 1
10
Print start (Input)
Port 2
1
Cut (Input)
Port 3
11
Counter Reset (Input)
Port 4
2
External synchronisation of label position (Input)
Port 5
12
No function
Port 6
3
No function
Port 7
13
No function
Port 8
4
No function
Port 9
15
Error (Output)
Port 10
6
Print order activ (Output)
Port 11
16
Label available at dispensing photocell (Output) in print mode
dispensing photocell
Port 12
7
Single print (Output)
Port 13
17
Ready (Output)
Port 14
8
RFID error (Output)
Port 15
18
Scanner: bar code not readable (Output) - option scanner only
Port 16
9
Prior warning for transfer ribbon end (Output)
COM/VDC
for Inputs
19
Common reference potential of all control inputs. 'COM/VDC for Inputs'
is usually connected with the (-) terminal of the control voltage and the
control inputs are switched to active (+).
By means of the option '2nd LED', 'COM/VDC for Inputs' can optionally
be connected with the (+) terminal of the control voltage. Then, the
control inputs are switched to active (-).
VDC for
Outputs
20
Common supply connection of all control outputs. 'VDC for Outputs'
must be connected with the (+) terminal of the control voltage.
Never leave 'VDC for Outputs' open even if no output is used.
COM for
Outputs
5,14
21,22
Common reference potential of all control outputs. 'COM for Outputs'
must be connected with the (-) terminal of the control voltage.
Never leave 'COM for Outputs' open even if no output is used.
GND-PE
23,24 'GND-PE' is the reference potential of the '+5 VDC EXT' and '+24 VDC
EXT' voltages provided by the printer system.
'GND-PE' is printer internally connected with protective earth (PE).
Configuration of
D-Sub socket
