Vario III Series
Loading Media
11.13 Operating
Manual
29
5 Loading
Media
5.1 Loading Label Roll
B
A
E
F
J
H
I
C
G
D
Figure 7
NOTICE!
In rewind mode the labels are wound up internally after printing
for later use.
1. Open the printer cover.
2. Open the printhead (I) by turning the pressure lever (J)
anticlockwise.
3. Remove the outside label mounting plate (A).
4. Load the label roll with inner winding onto the unwinding roll (B).
5. Attach again the label mounting plate (A).
6. Lead the label material below the label guiding (D).
Take care that the material runs through the photocell (G).
7. Place the labels around the front sheet (H) and lead them below
the mechanics to the rear.
8. Clamp the label material, with the handle (E) designated for it, at
the rewinding roll (F).
9. To move the printhead (I) down, turn the pressure lever (J) in
clockwise direction until it locks.
10. Adjust the limit stops (C) of the label guiding roll to the width of
material.
11. Close the printer cover.
Loading label roll in
rewind mode
