Function Menu
Vario III Series
40 Operating
Manual
11.13
6.3 Print
Settings
Switch on the label printer and the display shows the main menu.
Press key
to access the function menu.
Press key
to select the menu
Print settings
.
Indication of print speed in mm/s (see chapter Technical Data, page
15). The print speed can be determined for each print order anew.
The setting of print speed affects also the test prints.
Indication of value to set the print intensity when using different
materials, print speeds or printing contents.
Value range: 10% … 200 %.
Step size: 10%.
Press key
to arrive the next menu item.
Examination if the transfer ribbon roll is to end or if the ribbon was torn
at the unwinding roll.
Off:
The ribbon control is deselected, i.e. the printer continues without
an error message.
On:
The ribbon control is selected, i.e. the current print order is
interrupted and an Error Message appears at the printer display.
Strong sensibility:
The printer reacts immediately to the end of the
transfer ribbon.
Weak sensibility:
The printer reacts at approx. 1/3 more slowly to the
end of the transfer ribbon.
Press key
to arrive the next menu item.
Indication of initial point displacement in mm.
Displacement of the complete print in paper direction. With positive
values the print in paper direction starts later.
Value range:
−
30.0 … +90.0.
Press key
to arrive the next menu item.
Displacement of the complete print transverse to the paper direction.
The displacement is possible only up to the edges of the printing zone
and is determined by the width of the focal line in printhead.
Value range:
−
90.0 … +90.0.
Press key
to arrive the next menu item.
Indication of value to which the last label of a print order is moved
forward and is moved back to the beginning of label at a new print
start. Labels can be torn off after terminating the print order without a
label loss by tearing up.
Default value: 12 mm.
Value range: 0 … 50.0 mm.
Speed
Contrast
Ribbon control
Y displacement
X displacement
Tear-off
