Vario III Series
Options
11.13 Operating
Manual
59
Press key
to arrive the next parameter.
Indication of debounce time of the dispenser input. The setting range
of the debounce time is between 0 and 100 ms.
In case the start signal is not clear then you can debounce the input
by means of this menu item.
Press key
to arrive the next parameter.
Indication in time per second of the delay for the start signal.
Value range: 0.00 … 9.99.
Press key
to arrive the next parameter.
Indication of interface at which the modifications of input signals (I/O)
are sent.
Press key
to arrive the next parameter.
On:
The start signal for the next label can already be released during
printing the current label. The signal is registered from the printer. The
printer starts printing the next label immediately after finishing the
current one. Therefore time can be saved and performance be
increased.
Off:
The start signal for the next label can only be released if the
current label is printed to the end and the printer is again in 'waiting'
state (output 'ready' set). If the start signal was released already
before, so this is ignored.
Press key
to arrive the next parameter.
Selection of the available configurations
Std_Label
(factory setting) or
StdFileSetLabel
.
1
Print start and cut (Input)
2 No
function
3
Counter reset (Input)
4 No
function
5
Error reset (Input)
6 No
function
7 No
function
8 No
function
9 Error
(Output)
10
Print order active (Output)
11 Dispenser
photocell:
Label exists at dispenser photocell (Output)
12 Printing
(Output)
13 Ready
(Output)
14 Option
RFID
only:
RFID error (Output)
15
Option scanner only:
Bar code not readable (Output)
16
Transfer ribbon prior warning (Output)
Debounce
Start signal delay
I/O protocol
Save signal
I/O Profile
List of registered
functions for
Std_Label
