Options
Vario III Series
64 Operating
Manual
11.13
7.5 Scanner
Switch on the label printer and the display shows the main menu.
Press key
to access the function menu.
Press key
as long as you arrive the
RFID
menu.
Press key
to select the menu.
0 Off
1 Mode 1 (data comparison)
i.e. bar code date which was read by the scanner is compared with
the printed data.
2 Mode 2 (check readability)
i.e. it is only checked if the scanner can read the printed bar codes.
3 Mode 3 (check readability, graphic), i.e. it is only checked if the
scanner can read the printed bar codes. This mode is to use if the
bar code is available as graphic (e.g. printing with printer driver). In
this case the printer cannot recognize that a bar code is placed onto
the label.
Indication of number of successive non readables, i.e. when the
printer indicates an error message.
Value range: 0 - 9
1 = the printer stops at the first label which cannot be red from the
1 =
scanner and shows an error message.
0 = the printer do not stop at non-readable. A message appears at
0 =
the display only.
In many cases it is impossible to position the scanner directly at the
printhead, and therefore with this setting a feeding can be set
Value range: 1 - 5
The illustration below clarifies the meaning of this parameter.
Press key
to arrive at the next menu item.
Selection of the connected scanner type.
For more information about the different scanner models, please
contact our sales department.
Press key
to arrive at the next menu item.
Positioning of scanner. First of all, the scanner must be connected,
the appropriate scanner must be selected in the scanner type menu,
the interface must be activated in the interface parameter menu and
the interface parameters must be set correctly.
Mode
NoRd = Non readables
VEtik = Label feeding
Scanner type
Scanner setup
