Vario III Series
Safety Instructions
11.13 Operating
Manual
9
2 Safety
Instructions
The print module is designed for power supply systems of
110-230V. Connect the print module only to electrical outlets with a
ground contact.
Couple the print module to devices using extra low voltage only.
Before making or undoing connections, switch off all devices involved
(computer, printer, accessories etc.).
Operate the print module in a dry environment only and do not get it
wet (sprayed water, mist etc.).
Do not operate the print module in explosive atmosphere and not in
proximity of high voltage power lines.
Operate the print module only in an environment protected against
abrasive dust, swarf and other similar impurity.
If the direct print module is operated with the cover open, ensure that
clothing, hair, jewellery and similar personal items do not contact the
exposed rotating parts.
The print unit can get hot during printing. Do not touch the printhead
during operation. Cool down the print unit before changing material,
removal or adjustment.
Carry out only the actions described in these operating instructions.
Any work beyond this may only be performed by the manufacturer or
upon agreement with the manufacturer.
Unauthorized interference with electronic modules or their software
can cause malfunctions.
Other unauthorized work or modifications to the print module can
endanger operational safety.
Always have service work done in a qualified workshop, where the
personnel have the technical knowledge and tools required to do the
necessary work.
There are warning stickers on the print modules that draw your
attention to dangers. Therefore the warning stickers are not to be
removed as then you and others cannot be aware of dangers and may
be injured.
DANGER!
Danger to life and limb from power supply!
Do not open the casing.
