Error correction
Vario III Series
92 Operating
Manual
11.13
Error message
Cause
Remedy
110 Housing
open
When starting the print order
the housing cover is not closed.
Close the housing cover and
start the print order anew.
111 EAN.UCC
code
Transferred EAN.UCC code is
invalid.
Verify bar code data (see
corresponding specification).
112 Print
carriage
Printing carriage does not
move.
Check gear belt (possibly
broken).
113 Applicator
error
Error while using applicator.
Check applicator.
114 Left
position
Left final position switch is not
in correct position.
Check LEFT final position
switch for correct function and
position.
Check function of pneumatics
for cross traverse.
115 Right
position
Right final position switch is not
in correct position.
Check RIGHT final position
switch for correct function and
position.
Check function of pneumatics
for cross traverse.
116 Print
position
The print position is not correct. Check TOP and RIGHT final
position switch for correct
function and position.
Check pneumatics for function
117 XML
parameter
The parameters in the XML file
are not correct.
Please contact your
responsible distributor.
118 Invalid
variable
Transferred variable is invalid
with customized entry.
Select correct variable without
customized entry and transfer
it.
119 No
ribbon
During the print order the
ribbon roll becomes empty
(rear printhead).
Defect at the transfer ribbon
photocell (rear photocell).
Change transfer ribbon.
Check transfer ribbon photocell
(service functions).
120 Wrong
directory
Invalid target directory when
copying.
Target directory must not be
within the source directory.
Check target directory.
121
No label found
No label found at the rear
printhead (DuoPrint).
Soiled label photocell.
Labels not inserted correctly.
Insert new label roll.
Clean the label photocell.
Check if labels are inserted
correctly.
122 IP
occupied
The IP address was already
assigned.
Assign a new IP address.
