Carlisle DeVILBISS 905038, Service Manual

EN

** Compliant in North America. For confirmation of approvals please contact Customer Services.

TE20**

High 

Efficiency

905241

340 [12.0 cfm]

2.0 Bar [29 psi]

275-290mm

TE25**

High 

Efficiency

905242

350 [12.4 cfm]

2.0 Bar [29 psi]

270-285mm

2.0 Bar [29 psi]

285-300mm

TE10**

High 

Efficiency

905240

270 [9.5 cfm]

2.0 Bar [29 psi]

285-300mm

905250

Part Number

Fluid Nozzle Size

1.1

PRO-200-11
PRO-200-12

Fluid Nozzle

1.3

905266

PRO-301

Air Cap & Type

Part Number

Recommended Air 

Inlet Pressure

Typical Fan Pattern 

Size*

Air Consumption

(L/Min)

HV30**

HVLP

905238

440 [15.5 cfm]

1.65 Bar [24 psi]

290-315mm

PRO-200-14

1.4

905248
905249

905246
905247

Needle

Part Number

Marking

1.5

PRO-200-15

TABLE 2  - FLUID NOZZLES & NEEDLES   

PRO-200-13

      T110

High 

Efficiency

905245

265 [9.4 cfm]

Marking

1.2

TABLE 1 - AIR CAP PERFORMANCE GUIDE

PROLite G - PART SELECTION GUIDE

* Fan pattern size @ 200mm [8"] distance.

For North America only, the TE25 air cap is only approved for the application of clearcoats in regulated areas. 
For compliance in regulated areas, this spray gun must be used with a DeVilbiss spray gun mounted air adjusting 
valve (HAV-512, HAV-555, or DIGIPRO-504-PSI) which is in good working order. For compliance the inlet 
pressure must not exceed 26 psi when used with the TE25 air cap. This gun can also be used in unregulated 
areas with the TE25 air cap while using any coating. 

For North America only, the TE10 and TE20 air caps are only approved for the application of color coatings and 
clearcoats in regulated areas. For compliance in regulated areas, this spray gun must be used with a DeVilbiss 
spray gun mounted air adjusting valve (HAV-512, HAV-555, or DIGIPRO-504-PSI) which is in good working 
order. For compliance the inlet pressure must not exceed 35 psi with the TE10 aircap or 26 psi with the TE20 air 
cap. Item 9 must also be removed for compliance. This gun can also be used in unregulated areas with either air 
cap while using any coating.

High volume, low pressure (HVLP) sprayguns are designed to reduce overspray and provide maximum transfer 
efficiency by limiting air cap pressure to 0.69 bar (10 psi) (complies with rules issued by SCAQMD and other 
authorities). Gun inlet pressure must not exceed 24 psi when using the HVLP cap HV30 to maintain compliance. 
Air cap test kit 703541 is available to set the exact cap pressure.

SB-E-2-996 R1.0

8/24

www.carlisleft.com