51
© Carlo Gavazzi A/S
In "Slave mode" the CPM can operate in either "Normal mode" or "Roof" mode (see Fig� 22)�
It is possible to change/see the “calibration” address for the specific slave� The calibration address is
suggested as address P1 and should be the same on all sensors (see fig� 23)�
Fig. 51: Device ID for slave mode
Fig. 52:. Mode selection for slave mode
Fig. 53: Calibration in slave mode
In “Normal operation Mode” the user must know if a lane sensor is used on the L1 segment� If the
user does not use a lane sensor, the address with two crosses “XX” has to be disabled by pressing
the tactile key “8”�
If the lane detector sensor is selected, it is possible to implement an “off delay” of maximum 120 sec�
(see Fig� 25)� When a car moves under the lane sensor, the Parking Guidance System
reduces the number of available parking spaces with one, in the selected period of time� When this
time runs out, the Parking Guidance System will go back to the previous value until next time the lane
sensor is activated�
Fig. 54: Lane detection in slave mode
Fig. 55: Off Delay Lane in slave mode