Fold the Hi-Hat-CYMBAL and TOM1
1). Loosen the square screws.
2). Take out as direction 1, rotate 90 degree as direction 2, and put in as direction 3.
3). Screw down (as the right figure).
2. Fold the drum stand
Arrange the pad cables
1). Turn off the power supply.
2). Disconnect all the cables with the module.
3). Disconnect all the cables with the pads.
4). Take out the cable ties.
5). Rearrange the cables and bind
them onto the tubes.
6). Disassemble the module and assemble the screws
into the module and put the module into the bag.
7). Put the pedal into the bag.
Note:
The model CSD130 needs to be disassembled
the hammer and the bass drum stand and put
them into the bag.
Fold the CRASH
1). Loosen the butterfly nuts and knob.
2). Loosen the square screws.
3). Fold the CRASH as the figure below.
4). Tighten the square screw and properly tighten the butterfly nuts.
Butterfly nut
Square screw
Butterfly knob
Butterfly nut
