P a g e |
15
A level bubble is installed on the crossbar of the yoke to allow accurate levelling of the Quarryman Pro. This can be
achieved by varying the length of the tripod legs, and then by adjusting the foot-screws on the tribrach.
4.6 Carrying handle with GPS mount
While the Quarryman Pro is out of its transit case, use the carrying handle to transport the instrument around a site.
If necessary, use a 6 mm hex key to remove the carrying handle. This will allow the laser an unrestricted view
vertically upwards. This may be required if, for example, you are scanning an underground chamber and require a
complete view of the roof above the instrument.
The carrying handle incorporates a 5/8 inch thread. This can be used when you need to establish the position of the
Quarryman unit using a GPS system. Use the supplied 5/8 inch male-to-male adaptor to mount a GPS antenna to
the handle.
The vertical distance from the embossed cross on the side panel to the top of the handle is 141 mm.
The height of the knurled centre of the 5/8 inch male-to-male adaptor is 8 mm.
Thus, when mounting a GPS antenna on the handle using the 5/8 inch male-to-male adaptor supplied, there will be
a total vertical offset of 149 mm from the embossed cross on the side panel to the base of the GPS antenna.
Figure 6 Carrying handle
Figure 7 5/8 in male to male adaptor loose and on handle
Summary of Contents for Quarryman Pro
Page 2: ......
