This document contains confidential and proprietary information that remains the property of Carlson Software Inc.
Page 5 of 7
Updated 10/4/2010
Carlson
Carlson
Carlson
Carlson Software Inc.
Software Inc.
Software Inc.
Software Inc.
102 West 2
nd
Street
Maysville, KY 41056
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
Phone: (606) 564-5028
Fax: (606) 564-6422
SurvCE Initial Settings
1) Tap Start then tap the “SurvCE” helmet icon to launch Carlson SurvCE
2) Tap “Continue Last Job” after SurvCE opens
3) Tap the Equip tab then tap “GPS Rover”
4) Set the Manufacturer to “Carlson” and the Model name will be set to “S GPS”
automatically.
5) Tap the RTK tab and set the Device to “Data Collector Internet” and leave the “Network:” set for
“None”
6) Tap the
configure
icon off to the right of “Device: Data Collector Internet”
7) Tap “YES” when it prompts you that “Configuring the modem will close SurvCE”. After a few
seconds you will see the “Cell Modem Setup” window. Proceed to the steps below to setup the
GSM cellphone modem.
PLEASE NOTE:
If the CellModemSetup window doesn’t open automatically you can tap the “Configure
Internal GSM” button to open it manually after tapping the configure icon next to Data Collector Internet
Cell Modem Setup configuration
1)
A popup box will display asking you to close any
applications. Tap “YES” to continue.
2)
The screen to the right will be displayed
PLEASE NOTE:
The cellular provider may require the
IMEI number from the modem. This will be displayed on
this screen.
This screen allows you to select settings that are unique to
every wireless provider and are required for the modem to
connect to Internet. Depending on your wireless provider,
there may only be one selection.
3)
Select one of the choices presented on this screen and tap on the
Configure
button in the bottom left
to configure the modem with the settings you selected.
4)
Tap
OK
to close the application and reboot the data collector. The S will reboot and return to
the main Windows Mobile screen.
PLEASE NOTE:
If the only selection in the list is “Other”
tap on the
Configure
button in the bottom left.
The screen to the right is shown. You must obtain the
information (APN, user name, and password) from the
wireless provider and manually enter this information into
each field specified and then tap
OK
. Now you can tap
Configure
and tap
Yes
to reboot the data collector and
configure the modem.
