This document contains confidential and proprietary information that remains the property of Carlson Software Inc.
Page 6 of 7
Updated 10/4/2010
Carlson
Carlson
Carlson
Carlson Software Inc.
Software Inc.
Software Inc.
Software Inc.
102 West 2
nd
Street
Maysville, KY 41056
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
Phone: (606) 564-5028
Fax: (606) 564-6422
Final SurvCE Settings and Connecting to the Network
1)
Open SurvCE by tapping Start then tapping the SurvCE
Helmet Icon. Tap “Continue Last Job” to open the last job.
2)
Tap “Connect” and after it starts the GPS go into the Equip tab
and tap “GPS Rover”. Set the Manufacturer to “Carlson”
The Comms tab does not require any changes or input.
3)
Tap the Receiver tab. If you are using the GPS antenna and
Pole provided with the system you can leave the Antenna
Type set to “[NOV702GG” and type in
6.562 ft
{2 meters} into
the Antenna Height box as shown in the screenshot to the
right. The Position Rate can operate at 1hz, 2 Hz or 5 Hz. The
“Store Vectors in Raw Data” box can be checked to store
additional vector data in the RW5 raw file. (
Processing Vector
data is not recommended in a VRS reference system)
.
4)
Tap the RTK tab and set “Device:” to “Data Collector Internet”
then tap the
button next to “Data Collector Internet”. Tap
the “Connect” button to connect to the Internet. After the
“Internet Status” says “Connected” tap the Green Check.
5)
Set the “Network:” to “NTRIP” then tap the
button next to
NTRIP to configure your NTRIP reference network settings.
6)
Tap the down arrow to the right of “NtripInfoCaster” then tap
<New> and hand enter the name of your Reference Network
(
i.e. - “Kentucky VRS”
). After typing in the name of the
Network fill out the IP Address, Port number, User name and
Password. Tap the Green Check in the upper right to
download your list of NTRIP Bases to choose from in your
Reference Network.
This information is obtained from your
Network Administrator who runs the NTRIP network.
7)
You can browse the list of available bases on the reference
network by hitting the drop down arrow on the right side of the
Name box. Please contact your Network Administrator if you
need help selecting the proper Base ID for your current
location. After selecting the base you want to use tap the
Green Check in the upper right.
This returns you to the RTK tab where your Message Type,
Base ID and the “Send Rover Position” options should all be
automatically filled out.
8)
Tap the Green Check in the Upper right to complete the
process and connect to the GPS and the Reference Network.
(
for this final step its recommended that you are outdoors with
a good Cellphone signal and a good view of the Sky
)
