12” CHIPPER MACHINE OPERATION
35
•
Start engine at idle speed and allow
sufficient time for oil to circulate before
proceeding. A two-position throttle is
located on the engine cowling. The
lower (idle) position is for starting the
engine, low speed engine operation
during warm up, clutch
engagement/disengagement, and engine
cool down. The upper position is for
running the engine at full speed during
chipping operations. (See engine manual
for further starting procedures. Be sure
to follow the engine manual instructions
for cold weather operation.)
•
Test the controls for proper operation,
especially the feed control bar. (The
engine speed must be high enough for
the Auto-Feed
®
to engage the
hydraulics or the Auto-Feed
®
must be
off. Press down the left button and hold
for 4 seconds to turn Auto-Feed
®
off.)
−
Pull feed control bar to the rear of
the machine to test forward (pulling)
feed wheel motion
−
Push feed control bar to the middle
position to test off position (feed
wheels should not turn at all)
−
Push feed control bar all the way
toward the front of the machine to
test the reverse feed wheel motion
Summary of Contents for 1712
