6-1136
5
Rev. 09/17/18
Air Inlet
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MAN U AL FOR FUTURE REF ER ENCE.
Important:
DO NOT RETURN
PRODUCT TO PLACE OF
PURCHASE.
WARRANTY POLICY:
This NAPA
Professional Air Tool is warranted
against defects in material and
workmanship for a period of One (1)
Year from the date of original pur-
chase. We will repair or replace, at
our option, any part which proves to
be defective in material or workman-
ship. Repairs or replacements are
warranted as described above for
the duration of the original warranty
period. This warranty does not apply
to products which have been sub-
jected to abuse, misuse, modification,
neglect, lack of maintenance, use in a
production-related service, or repaired
by anyone other than an Authorized
Master NAPA Professional Air Tool
Service Center.
For complete listing of Authorized
Master Repair Centers, see enclosed
Customer Warranty Repair Form, or
visit www.toolwarrantyrepair.com
DOUBLE YOUR WARRANTY
By registering your tool at www.
propowerseries.com/support, NAPA
warrants to the original purchaser of
the tool to be free of defects in mate-
rial and workmanship for an extended
ONE (1) YEAR from the end of the
original NAPA Air Tool Warranty, as
set forth above.
Tool registration must be completed
within Thirty (30) Days of tool pur-
chase.
WARRANTY CLAIM PROCEDURE
If your NAPA Professional Air Tool
proves defective within its origi-
nal One (1) Year (or Two (2) Year
extended) warranty period, it must
be returned to an Authorized Master
NAPA Professional Air Tool Service
Center. Customer is responsible for
shipping the tool Freight Pre-Paid
along with Proof of Purchase and
completed Customer Warranty Repair
Form.
WARRANTY
For a complete list of authorized air tool repair centers please visit www.toolwarrantyrepair.com.
Locate center of new hole by using
a center punch. Place drill bit tip in
punch mark. Hold drill square with
work and start motor. Apply steady,
even pressure. Do not force. Too
much pressure can cause bit to break
or overheat. Too little pressure will
keep the bit from cutting and cause
it to overheat. Reduce pressure just
before bit cuts through the work.
When bit has penetrated work and is
spinning freely, take it from the work
while the motor is running, then turn
off the drill. If the drill jams in the
work, release throttle immediately.
Disconnect the drill before removing
bit and determining cause of trouble.
Do not attempt to free the bit by
starting and stopping the motor.
OPERATION
Specifications
Chuck Size . . . . . . . . . . . . . . . . . 1/2"
Free Speed . . . . . . . . . . . . . 500 RPM
Air Inlet Size . . . . . . . . . . . . 1/4" NPT
Min. Hose Size . . . . . . . . . . . 3/8" I.D.
Spindle Thread . . . . . . . . . . . 1/2"-20
Air Consumption . . . . . . . . . 4.0 CFM
Sound Level . . . . . . . . . . . . . 82 dBA
Net Wt. . . . . . . . . . . . . . . . . 3.86 lbs.
Overall Length . . . . . . . . . . . . . . 9.25"
Recom. Air
Pressure . . . . . . . . . . 90psig (6.2 bar)
Forward/Reverse
