Owner’s Manual | Model A704-5 Aviation Lighting System
20
© 2008 Carmanah Technologies Corporation
Last revised: April 2008
5.4.2 Administrator
Mode
Administrator Mode allows an operator access to the following management operations of the wireless
controller.
Personal Identification Number (PIN) Management
Unique Code Sequence (UCS) Management
ARCAL
Entry
In Administrator Mode, the wireless controller turns off after 10 minutes of inactivity to avoid unauthorized
access to management operations.
When the controller is in Administrator Mode, the PIN Status red LED flashes and the
CONFIG green LED is lit.
5.4.3 Mode
Selection
User and Administrator modes each have a unique PIN associated with them. When the controller is
turned on, this unique PIN is used to select the Operational Mode of the controller. To change modes, the
controller must be powered off and then on again, and the appropriate PIN entered.
To power off the controller, press the POWER button.
5.5 PIN
Entry
Turn on the wireless controller by pressing the POWER button. To use the wireless controller after turning
it on, a PIN must be entered; the red PIN Status LED turns on steady to indicate this. As the PIN is
entered, the ACTIVE GROUP green LEDs will light to indicate the number of keys pressed. Press the
ENTER key to submit the PIN.
The wireless controller factory default PINs are shown in Table 8: Default PINs.
Table 5-1: Default PINs
Mode
Default PIN
User 123
Administrator 789
If the PIN is accepted, the ENTER key LED will briefly light green and PIN STATUS will
turn off or begin to flash depending on whether the User or Administer mode was
selected. If the PIN is not accepted, the ENTER key LED will briefly light red and the
PIN Status red LED will remain lit.
5.6 Basic User Operations
This section outlines the basic user operations of the wireless controller.
5.6.1 Turning the Controller On
To start using the system, press the CONTROLLER POWER button. All LEDs on the controller will flash
briefly to indicate they are functioning. After the LEDs flash briefly:
The CONTROLLER POWER button green LED will light steady to indicate power is on.
The PIN STATUS red LED will light steady to indicate a PIN must be entered.