5
www.CarnivalKingSupplies.com
.
info@carnivalking.com
GAS CREPE MAKER
Instructions for Gas Conversion:
MODEL SERIES 382GCM16
Warning
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read the installation, operating and maintenance instructions
thoroughly before installing or servicing equipment.
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in these instructions is not followed
exactly, a fire, an explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualified service agency is
responsible for the proper installation of this kit. The installation is not proper and
complete until the operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.
Specific Instructions :
CAUTION
ENSURE THE GAS SUPPLY IS SHUT OFF AT THE MANUAL SHUT OFF VALVE BEFORE PROCEEDING WITH THE
CONVERSION
Switch off the gas at the main supply valve and allow the unit to cool down before commencing with the
conversion.
Take off the front panel to expose the pilot valve and control valve.
Change the orifice for main burner:
Loosen and remove the brass orifice located on the end of the burner with a wrench.
Replace with the new orifice from the conversion kit, first applying a small amount of jointing paste to the
thread on the end of the nozzle holder, this will ensure a good gas tight seal.
Adjust the gas regulator: From NAT Gas to LP Gas:
1.
Use a 22mm wrench to remove the conversion cap from the top of the regulator.
