4
www.CarnivalKingSupplies.com
.
||||| info@carnivalking.com
Ice Shaver Machine Manual
Operation
1. Please ensure that the machine is on a level stable surface, the feet are intact and level.
2. Open the ice shaver lid and wipe the hopper with a dry cloth, check that the blade is firmly installed.
3. If using the foot pedal, install the foot pedal by plugging it into the back of the machine. Turn Foot Pedal Switch ON
(located on the back of the machine).
e. Warning: do not leave foot switch accessible to inadvertent operation when left unattended or when not being used.
4. Lift the cover lid and load ice hopper with up to 4 lbs. of ice cubes, do not overfill. Make sure it is evenly loaded.
a. Allow ice cubes to temper for at least 20 minutes for finer and fluffier texture. We recommend not using ice straight
from the freezer.
5. Close the lid and place a cup, bowl, or tub directly below the ice chute. Turn the Main Power Switch ON or press down on
the Foot Switch. To stop shaving ice, release Foot Switch.
a. Warning: Ensure the front switch is OFF and/or your foot is off the pedal when lowering the lid.
b. Machine WILL NOT OPERATE unless the cover lid is closed (due to safety momentary switch).
6. Once all ice cubes are shaved and the hopper is empty, TURN the front switch to turn OFF or
take your foot off the pedal.
a. Note: When refilling the hopper with ice – opening the hopper lid shuts off power.
Foot pedal and switch will not work.
7. Repeat steps 4-6 for multiple batches
8. To adjust the ice texture, turn the Blade Adjustment Knob CLOCKWISE for a finer ice texture,
COUNTERCLOCKWISE for a coarser ice texture.
9. Top with Carnival King Sno-Cone Syrup, mix with Regal Cocktail Syrups, or marshmallow fluff!
Warning
ELECTRIC SHOCK HAZARD
Keep water and other liquids from entering the inside of the equipment. Liquid inside the equipment could cause an
electrical shock.
Warning
Sharp blades, do not place hands in or near the ice holder
while the motor is running.
COARSE
FINE
SHAVING TEXTURE
