12
Carolina Cooker®
844-478-4334
Model M64482
June 2020
5.4 Connecting the LP Cylinder
5.4.1 Safety Instructions
• Do not connect this appliance to any other fuel supply
source, such as natural gas.
• If the regulator is not working correctly, do not attempt
to adjust or repair it.
• Never use an LP cylinder if it shows signs of dents,
gouges, bulges, fire damage, corrosion, leakage,
excessive rust, or other forms of visual external damage.
This type of damage may be hazardous and should be
checked by an LP service technician.
Keep the fuel supply hose away
from any heated surface(s).
SAFETY INSTRUCTIONS
WARNING
!
5.4.2 Connecting Instructions
1. Make sure the LP cylinder is upright and the valve is
closed by turning the knob clockwise.
2. Remove the protective cap from the LP cylinder
valve, if installed.
3. Connect the hose and gas regulator assembly to the
LP cylinder.
This appliance was not designed
for, and should not be connected
to, a natural gas supply line.
6. Connect the regulator hose assembly to an LP
cylinder, as described in section “5.4 Connecting the
LP Cylinder” on page 12.
7. Perform the Soapy Water Test, as described in
section “5.5 Soapy Water Test” on page 13.
8. Follow the safety and cooking guidelines, as
described in section “6. Cooking Guidelines” on
page 16.
Never use a cooking pot or
other vessel that does not
correctly fit or is not properly
suspended inside the circular frame of the appliance.
3. Attach the heat shield using the M6 bolt supplied.
SAFETY
INSTRUCTIONS
4. Place the appliance on a level surface.
5. Connect regulator hose assembly to the burner.
To prevent damage to fittings or
burner assembly when tighten
-
ing connection, hold brass fitting with one wrench while
tightening regulator hose assembly fitting with the other
wrench. Do not tighten the connection using a single
wrench. wrench.
Do not tighten the connection using a
single wrench.
NOTICE
WARNING
!
