ULW Czech, s.r.o.
V Ráji 34, Praha 9
-
Hostavice, 198 00, CZ, IČO: 28256212, DIČ: CZ28256212
Device’s operation (even when the System battery indicator is showing 1%, the Device will
not shut down until the battery voltage goes down to 3,4V).
7.11.
Real battery level can be verified in the Manager app - Power&Charge (refer to Section
Chyba! Nenalezen zdroj odkazů.
) or on the System pull down menu:
7.12.
System battery level will not be equal to voltage level most of the time. This is normal
(System battery indicator is not linear to voltage level).
7.13.
Voltage of fully charged battery after disconnecting from charger will be around 4,2V.
Voltage of fully depleted battery is 3,4V. When the voltage level of the battery meets 3,4V
or drops below, the Device will automatically shut down to prevent damage to the battery.
8.
Operating conditions / instructions
8.1.
The Device is not designed to be placed on your vehicle permanently. When not in use,
remove the Device from your vehicle and store it in a safe place with temperature between
0
–
35°C
.
8.2.
The Device should not be operated outside ambient temperature range between 0-40
°
C or
the battery contained in the Device
or it’s electronics
can be damaged. The Device has
temperature protection system, which might cause the Device not to start or shut down
automatically, when the operating temperature range is exceeded. This automated
protection system is only a fail-safe and does not relieve you of the need to ensure yourself
correct operating conditions.
8.3.
Considerable heat is generated by the Device’s LCD and when charging.
When high ambient
temperatures are present, overheating might be prevented by reducing LCD brightness
and/or disabling charging;
8.4.
If you need to use the Device in sub-zero temperatures, make sure the Device is not
thoroughly cooled below 0
°C before
you start it (do not leave it on the bike). During use,
heat is generated inside the Device, so use in sub-zero temperatures is possible. Never use
the Device below minus 5
°C (the heat generated by the Device’s operation might not be
sufficient to ensure minimum operating temperature).
