Rev. 04/17/03
PARTS BREAKDOWN & OPERATING MANUAL
Old 1500-CJ
New 1500-PV
750 LB. ENGINE STAND
Refer to Engine Service Manual for
Correct Lifting Points, Mounting
Points and Mounting Bolts!
Mounting bolts should
be torqued at appropriate amount
to maintain load.
DO NOT OVERLOAD. OVERLOADING CAN
CAUSE DAMAGE TO, OR FAILURE OF
THE STAND.
THIS STAND IS DESIGNED FOR USE ONLY
ON HARD LEVEL SURFACES CAPABLE OF
SUPPORTING THE LOAD. USE ON OTHER
THAN HARD LEVEL SURFACES CAN
RESULT IN STAND INSTABILITY AND
TIPPING OF LOAD.
LOCK THE MOUNTING-PLATE ROTATING
MECHANISM BEFORE APPLYING A LOAD.
RELEASE ROTATIONAL LOCKING DEVICE
SLOWLY AND CAREFULLY.
ALWAYS USE HIGH STRENGTH SAE GRADE
8 BOLTS FOR ENGINE MOUNTING BOLTS.
MAKE SURE WIDEST SET OF MOUNTING
HEAD FINGERS ARE NEAREST THE
GROUND WHEN MOUNTING AN ENGINE
TO THE STAND.
ALWAYS BE SURE THAT THE LOAD IS
CENTERED AND SECURED TO THE
MOUNTING PLATE. OFF-CENTER LOADS
MAY MAKE THE LOAD AND HANDLE
ROTATE IN EITHER DIRECTION WHEN
THE ROTATIONAL LOCKING DEVICE IS
RELEASED.
NEVER LOOSEN MOUNTING BOLTS
UNLESS ENGINE IS SUPPORTED BY A
CRANE OR HOIST.
DO NOT USE STAND TO DOLLY OR
TRANSPORT ENGINES.
NO ALTERATIONS TO THE STAND OR
ADAPTERS SHALL BE MADE.
DO NOT ROTATE MOTOR UNLESS REAR
LEGS ARE SECURED FROM TIPPING.
READ, STUDY AND UNDERSTAND ALL
INSTRUCTIONS BEFORE OPERATING.
FAILURE TO HEED THESE WARNINGS MAY
RESULT IN LOSS OF LOAD, DAMAGE TO
STANDS, AND/OR FAILURE RESULTING IN
PROPERTY DAMAGE, PERSONAL OR
FATAL INJURY.
