Rev. 04/18/03
P
ARTS
B
REAKDOWN
& O
PERATING
M
ANUAL
LIMITED WARRANTY
ProValue™ shop equipment and tools excluding accessories, are warranted against defects in materials or workmanship for a period
of one year from original purchase. We will repair or replace at our option any defective part or unit which proves to be defective in
material or workmanship within this warranty plan. This warranty does not cover damage to equipment or tools arising from alteration,
abuse, misuse, damage and does not cover any repairs or replacement made by anyone other than ProValue™ or its authorized
service centers.
The foregoing obligation is CARQUEST Products., Inc., ProValue’s sole liability under this or any implied warranty and under no
circumstances shall we be liable for any incidental or consequential damages.
NOTE: Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
Return equipment or parts to service center transportation prepaid. Be certain to include your name and address, evidence of the
purchase date, and description of the suspected defect.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
S
PECIFICATIONS
O
PERATING
I
NSTRUCTIONS
Drain oil and coolant and remove flywheel from engine before
mounting. Mount engine as directed in procedures which follow. Refer
to engine service manuals and technical bulletins when mounting
engines. Lift engine (block) with crane or hoist until even with head of
engine stand. Bolt through adjustable fingers to back of block at bell
housing mounting holes. Fasten securely to mounting plate. Slowly
lower crane or hoist so that the engine stand supports full weight of
engine. To check engine balance, carefully loosen hex bolt at back of
rotating head, making sure stand is secured from tipping, and turn
handle to rotate engine.
If balance is not satisfactory, rotate engine to its original position and
raise with crane or hoist just enough to take weight off the stand. Loosen
bolts on adjustable fingers and realign so that weight is evenly
distributed. Tighten all bolts securely and recheck balance. For safe and
secure operation: do not rotate engine more than 90° for any one
location of the positioning handle. In general, keep the handle within
45° of horizontal. Keep a firm hold on positioning handle while
rotating engine. To remove an engine from stand, attach a crane or
hoist and raise engine just enough to take engine weight off stand.
Carefully remove bolts attaching fingers to engine. Be aware that there
will be a slight movement of stand as total engine weight is transferred
to crane.
Capacity ............................................1250 Lbs.
Length ..................................................33-1/4"
Width ....................................................33-1/2"
Height ..................................................33-1/2"
Shipping Wt. ..........................................88 lbs.
2 Boxes
1501-PV_man041103.q 4/18/03 8:31 AM Page 4
