10
Table of contents
Safety instructions
10
Contents of package
10
Technical advice for assembly
10
Important Information
11
Assembly instructions
11
Guard Rails and Supports
11
Electrical connection
11
Car components
11
Connections
12
Control elements
12
Preparation of start
12
Encoding/programming of cars to
the according speed controllers
12
Points function
12
Light function on/off
13
Operating 6 cars
13
Encoding/programming of Autonomous Car
13
Encoding/programming Pace Car
13
Setting of the cars´ basic speed
13
Setting of cars´ braking performance
14
Setting fuel tank capacity
14
Deactivating Settings Keys
14
Extended Pit Lane function
14
Sound ON/OFF
14
Reset function
14
Energy-saving mode
15
Car programming from DIGITAL 132 to Evolution (analogue) 15
Replacement of double sliding contact and guide keel 15
Changing the rear axle
15
Maintenance and care
15
Troubleshooting/Driving tips
15
Technical specifications
15
Welcome
Welcome to the Team Carrera!
These operating instructions contain important information regard-
ing the assembly and operation of your Carrera DIGITAL 132 race-
track. Please read them carefully and keep them in a safe place af-
terwards. If you have any queries, please do not hesitate to contact
our distributor or visit our website:
carrera-toys.com
Please check the contents for completeness and possible transport
damage. The packaging contains important information and should
also be retained.
We hope you will derive a lot of pleasure from your new Carrera
DIGITAL 132 track.
Safety instructions
•
WARNING!
Not suitable for children under 36 months. Danger of
suffocation due to small parts which may be swallowed. Caution:
risk of pinching caused by function.
•
WARNING!
This toy contains magnets or magnetic components. Magnets at-
tracting each other or a metallic object inside the human body may
cause serious or fatal injuries. Seek medical attention immediately if
magnets are swallowed or inhaled.
• The transformer is not a toy! Do not short-circuit the transformer’s
connections! Note to parents: Regularly inspect the transformer for
damage to the cable, plug or housing! Only operate the toy with rec-
ommended transformers! The transformer may no longer be used
if it is damaged! Only operate the racetrack with a transformer! If
play is interrupted for longer periods, it is recommended to separate
the transformer from the power supply. Do not open transformer or
speed controller housings!
Important note to parents:
Transformers and power supply units are not suitable to be used as
toys. The use of such products needs to be constantly supervised
by the parents.
• Regularly check the track and cars for damage to cables, plugs
and housings! Replace defective parts.
• The car racetrack is not suitable for outdoor operation or operation
in wet locations! Keep away from liquids.
• Do not place any metal parts onto the track to avoid short-circuits.
Do not place the track in the immediate vicinity of delicate objects,
as these could be damaged by cars hurled from the track.
• Disconnect the plug before cleaning or servicing the racetrack!
Only use a damp cloth for cleaning, no solvents or chemicals. When
it is not in use, store the track in a dry and dust-protected location,
preferably in the original cardboard box.
• Do not operate race track at face- or eye-level – risk of injury due
to cars being catapulted off the track.
• Misuse of transformer can cause electrical shock.
• The toy is only to be connected to Class II equipment
bearing the following symbol.
• The toy must only be used with a transformer for toys.
• Not to be used with controllable transformers.
Note:
The vehicle may only be operated again in a completely assembled
condition. Assembly may only be carried out by an adult.
Contents of package
1 Lamborghini Huracán GT3 “No.63”
1 Ferrari 458 Italia GT2 “AT Racing No.56”
1 Chevrolet Corvette C7.R “No.03”
11 Standard straights
1 Control Unit
10 Curves 1/60°
1 Carrera DIGITAL 132 double lane change section (2 track parts)
3 Speed controllers
1 Transformer
Guardrails
Replacement contacts
Instructions
Track section interlocks
Shoulder end sections
Track length: 26.24 ft. / 8,0 m
Dimensions when assembled: 10.53 x 4.99 ft. / 321 x 152 cm
Technical advice for assembly
1
Connecting track + Control Unit
2
Double lane change section input
3
Double lane change section output
4
Infrared sensor:
The infrared sensor MUST be located on the switch
that functions as the entry rail (dark diode).
1
2
3
4
