9
Assembly
1
Pull out the lap counter to the width of the track being used (fig.
1
).
Insert the sides of the track into the projections on the inside of the
feet of the lap counter.
Lining up the vehicles
1
2
Line up the vehicles in the direction of driving (fig.
1
) so that they
are close to the light barrier (fig.
2
) of the lap counter.
How it works
1
2
The lap counter recognizes a vehicle when it passes through the
light barrier. Lap races
1
or time trials
2
can be executed. Here
you can set a maximum of 999 laps, or 59 minutes and 59 seconds.
einstellen.
Settings
C
D
E
All settings and displays are undertaken via the two buttons
C
and
E
. During and after a race, various information on the race can be
called up via the
E
button.
Switching on
050
00
:
44
:
28
050
00
:
44
:
28
1
Push the power switch
D
into the ON position. The display shows
the active racing mode (fig.
1
, flashing).
Set race mode
050
00
:
44
:
28
050
00
:
44
:
28
1
050
05:00:
045
00
:
44
:
28
2
After switching on the lap counter, this is automatically put into lap
mode (fig.
1
). On initial commissioning, the lap count is set to 50.
The lap counter saves the last lap count set and displays this again
when next called up. In order to switch to the time mode (fig.
2
),
press button
E
once. The time display will start to flash. On initial
commissioning, the time is preset to 5 minutes. The lap counter
saves the last time set and displays this again when next called up.
NOTE: If no entry takes place for approximately 10 minutes, the
lap counter will switch off again automatically.
Summary of Contents for 20071590
Page 2: ...2...
