8
1
3
6
2
7
8
8
8
5
4
Table of contents
Safety instructions
8
Contents of package
8
Technical advice for assembly
8
Important Information
9
Assembly instructions
9
Guard Rails and Supports
9
Electrical connection
9
Car components
9
Preparation of start
9
Preparation of start and points function
10
Race modes
10
Light function on/off
10
Operating 6 cars
10
Coding/decoding of the cars to the according speed controller 10
Autonomous Car function
10
Pace Car function
10
Setting basic speed
10
Setting braking eff ect
10
Setting fuel tank capacity
11
Car programming from DIGITAL 132 to Evolution (analogue) 11
Replacement of double sliding contact and guide keel
11
Changing the rear axle/engine/engine block
11
Maintenance and care
11
Troubleshooting/Driving tips
11
Technical specifi cations
11
Welcome
Welcome to the Team Carrera!
These operating instructions contain important information regard-
ing the assembly and operation of your Carrera DIGITAL 132 race-
track. Please read them carefully and keep them in a safe place af-
terwards. If you have any queries, please do not hesitate to contact
our distributor or visit our websites:
www.carrera-toys.com · www.carreraclub.com
Please check the contents for completeness and possible transport
damage. The packaging contains important information and should
also be retained.
We hope you will derive a lot of pleasure from your new Carrera
DIGITAL 132 track.
Safety instructions
•
WARNING!
Not suitable for children under 36 months. Danger of
suff ocation due to small parts which may be swallowed. Caution:
risk of pinching caused by function.
•
WARNING!
This toy contains magnets or magnetic components. Magnets at-
tracting each other or a metallic object inside the human body may
cause serious or fatal injuries. Seek medical attention immediately if
magnets are swallowed or inhaled.
• The transformer is not a toy! Do not short-circuit the transformer’s
connections! Note to parents: Regularly inspect the transformer for
damage to the cable, plug or housing! Only operate the toy with rec-
ommended transformers! The transformer may no longer be used
if it is damaged! Only operate the racetrack with a transformer! If
play is interrupted for longer periods, it is recommended to separate
the transformer from the power supply. Do not open transformer or
speed controller housings!
Important note to parents:
Transformers and power supply units are not suitable to be used as
toys. The use of such products needs to be constantly supervised
by the parents.
• Regularly check the track and cars for damage to cables, plugs
and housings! Replace defective parts.
• The car racetrack is not suitable for outdoor operation or operation
in wet locations! Keep away from liquids.
• Do not place any metal parts onto the track to avoid short-circuits.
Do not place the track in the immediate vicinity of delicate objects,
as these could be damaged by cars hurled from the track.
• Pull the plug before cleaning the racetrack! Only use a damp cloth
for cleaning, no solvents or chemicals. When it is not in use, store
the track in a dry and dust-protected location, preferably in the origi-
nal cardboard box.
• Do not operate race track at face- or eye-level – risk of injury due
to cars being catapulted off the track.
Note:
The vehicle may only be operated again in a completely assembled
condition. Assembly may only be carried out by an adult.
Contents of package
1 Chevrolet® Impala SS #31Jeff Burton
1 Dodge Charger #9 Kasey Kahne
8 Standard straights
12 High banked curves 3/30°
1 Connecting section with Black Box
1 Carrera DIGITAL 132 lane change section, right (2 track parts)
1 Carrera DIGITAL 132 lane change section, left (2 track parts)
8 Carrera DIGITAL 132 double lane change section
(2 track parts)
2 Speed controllers
1 Transformer
Guard
rails
Replacement
contacts
Shoulder end sections
Instructions
Track section bolts
Track length: 32.28 ft. / 9,84 m
Dimensions when assembled: 10.17 x 13.12 ft. / 400 x 310 cm
Technical advice for assembly
1
Connecting track + Black Box
2
Lane change section left input
3
Lane change section left output
4
Lane change section right input
5
Lane change section right output
6
Double lane change section input
7
Double lane change section output
8
Infrared
sensor:
The infrared sensor MUST be located on the switch that
functions as the entry rail (dark diode).
IMPORTANT:
Driving direction from right to left only.
Summary of Contents for DIGITAL 132 30139 NASCAR
Page 1: ...3 013 9 N A S C A R...
