Axxius 800 - Release 2.2
5-41
CLI Commands
connect
connect (router-trunk) (t1)
Use the connect (router-trunk) (t1) command to create two-way connections between the
Router port trunk connections and any DS0 channels of the service card or Controller.
Syntax:
connect {rtr_trunk-addr}
{slot:port|slot:port:channel}
Use the disconnect command to delete connections.
Note: addresses can also be in the following order:
connect {slot:port|slot:port:channel}
{rtr_trunk-addr}
Example:
connect 5:1:1 a:2:1-12
Connects 12 channels on port address #2 (DS1) on the controller card (slot A)
to trunk 1 on the Router in slot 5.
{rtr_trunk-addr}
The Router trunk address is in the form {slot:port:trunk}
.
{slot:port|slot:port:channel}
slot
The slot number (1-8) that contains the Router card.
port
Port number of the TSR is 1. Note: there are 4 physical ports but only one
logical one used for addressing.
trunk
Trunk number for this port, 1-24.
slot
A for the controller card, or 1-8 for service cards.
port
Port number or range (port must be a T1).
channel
Channel number or range, for T1 ports.
Summary of Contents for Network Device Axxius 800
