5-66
Axxius 800 - Release 2.2
CLI Commands
reset
reset
reset (controller
)
Use the reset (controller) command to reboot the system. Reset alone will reboot the entire
system.
Syntax:
reset [ctrlr-addr|active|standby]
Example:
reset a1
Will reset the controller in the controller slot 1.
Do you really want to reset (y/n)? y
**** System Boot ****
Copyright 1999,2000 Carrier Access Corporation.
{ctrlr_card-addr|active|standby}
WARNING!
THE
COMMANDS
reset
AND
reset active
ARE
SERVICE
AFFECTING
COMMANDS
.
reset (router)
Use the reset (router) command to reboot the Router. All new configuration since the last
reset will be in use.
Syntax:
reset {rtr_card-addr}
Example:
reset 1
The example will reset the Router card in slot 1.
Do you really want to do this ? y
OK
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
ctrlr_card-addr Resets the Controller in the defined slot number (a1 or a2)
active
Resets the active Controller
standby
Resets the standby Controller
Summary of Contents for Network Device Axxius 800
