Axxius 800 - Release 2.2
5-67
CLI Commands
restore
reset (router) coldboot
Use the reset (router) coldboot command to reboot the Router. This will reboot including a
power cycle to the Router card.
Syntax:
reset {rtr_card-addr} coldboot
Example:
> reset 2 coldboot
OK
The example will coldboot the Router card in slot 2.
{rtr_card-addr}
The slot number (1-8) that contains the Router (TSR) card.
restore
Use the restore command to restore system properties.
Note: to restore Router defaults see set (router) default.
restore defaults
Loads factory defaults for all settings. This command will not take effect until the system is
rebooted using the reset command.
Syntax:
restore defaults
Example:
restore defaults
For the restore default changes to take effect send a reset command.
Further configuration changes made before a reset will be lost.
Summary of Contents for Network Device Axxius 800
