Axxius 800 - Release 2.2
5-89
CLI Commands
set
set idle
Use the set idle command to set the system-wide idle code sent on DS0s.
Syntax:
set idle {pattern}
Example:
set idle 0xff
{pattern}
A hexadecimal number with a range from 0x00 to 0xff. This number must be preceeded by
0x.
set ip gateway
Use the set ip gateway command to set the IP gateway address (also known as the default route)
for the Axxius 800. The command specifies the numeric Internet Protocol (IP) address. The new
gateway address will not take effect until Controller is reset (reset command).
Syntax:
set ip gateway {ip-addr}
Example:
set ip gateway 192.168.100.1
{ip-addr}
Set the IP gateway address for the Axxius 800, using the form xxx.xxx.xxx.xxx, where xxx
is a number from 0 to 255.
Summary of Contents for Network Device Axxius 800
