5-144
Axxius 800 - Release 2.2
CLI Commands
set
set (router-lan) phy
Use the set (router-lan) phy command to specify the Ethernet PHY (physical specifications)
speed and mode.
NOTE:
It is highly recommended that this setting be left at auto-
negotiation. Connecting Ethernet devices with incompatible setting can
lead to severe network performance degradation, increased collisions, late
collisions, CRC errors, and undetected data corruption.
Syntax:
set {rtr_lan-addr} phy {setting}
Example:
set 3:1 phy full100
The example will force the Ethernet PHY to 100 MHz full-duplex on the Router
in slot 3.
{rtr_lan-addr}
The Router address is in the form {slot:port} or {slot "profile-name"}.
{setting}
slot
The slot number (1-8) that contains the Router card.
port
Port number of the Router.
"profile-name"
The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
auto
Auto-negotiate (highly recommended).
full10
10 MHz full-duplex.
full100
100 MHz full-duplex.
half10
10 MHz half-duplex.
half100
100 MHz half-duplex.
Summary of Contents for Network Device Axxius 800
