4-4
Axxius 800 - Release 2.2
Configuration
Basic System Setup
Basic System Setup
Initial Setup
Use the following commands for your initial setup, for further information see the
specific command listed in Chapter 5, CLI Commands.
NOTE:
Removing an active Controller is not recommended, use the
switch controller command to change the Active Controller to Standby and
then remove the Controller card.
Command
Description
set date dd/mm/yyyy
Set the system date, using the format
day/month/year. See the set date command for
details.
set time {hh:mm:ss}
Set the system time. See the set time command
for details.
set id {“id-name”}
Set the systemID name. Remember to enclose
this name in quotes. See the set id command for
details.
set clock {nonrevertive|
revertive|switch}
Set the signal clock switching. See the set clock
command for details.
set {clock1|clock2} {source}
Set the primary and secondary clock source.
See the set clock (1 and 2) command for details.
set ethernet ip address
{ip-addr} [mask]
Set the Ethernet IP address and optionally the
subnet mask, for the Axxius 800. See the set
ethernet ip address command for details.
set ip gateway {ip-addr}
Set the IP gateway for the Axxius 800. See the
set ip gateway command for details.
clear log
Initialize the event log. See the clear key
command for details.
status equipment [slot]
See the status of the equipment. See the status
equipment command for details.
Summary of Contents for Network Device Axxius 800
