7–39
T-372
GDP Calibration, Removing Return Sensors (RTS/RRS) from Unit:
1. Remove both front access panels from the unit by removing 8 fasteners from each panel (see
).
Save all hardware for re-installation.
Figure 7.22 Removing Front Access Panels
2. On the right side, disconnect the fan motor wiring, loosen the fastener and remove (slide) the evaporator
motor from the unit (see
).
Figure 7.23 Removing Evaporator Motor
3. Loosen the fastener on the sensor bracket (see
).
Figure 7.24 Return Sensors - Bracket
