Carrier 09VE, Installation, Operation And Maintenance Instructions

3 - GENERAL INFORMATION

3.1 - Unit functions

■

Drycooler

: Device in which a fluid in liquid state is cooled by heat exchange with the ambient air, without direct contact between 

the ambient air and the fluid.

■ Misting option: System for cooling air by misting of water droplets under high pressure. 

■ These devices must only be used for the purpose for which they are intended. In particular, it is formally prohibited to use any fluid 

other than that specified in the order documents.

3.2 - Standards

■ Every unit meets standards EN 60-204 as well as the following European directives:

-

Machinery 2006/42/EU

-

EMC 2014/30/EU

-

PED 2014/68/EU   

■

Technicians who install, commission, operate and service the unit must understand the instructions given in this manual and be 

familiar with the specific technical characteristics of the installation site.

3.3 - Warranty

■

See general terms and conditions of sale.

■ Check the compatibility of the fluid with the equipment being used.

■ To find out the limits of use, refer to the name plate.

4 - NAME PLATE

■

Désignation\Description:

 See "Description".

■

An (Year):

 Year of manufacture.

■

N° série/Serial Nbr: 

number to be quoted in all 

correspondence.

■

DIR 2014/68/EU (DN):

 Category and determining value 

(DN for "PIPES", Capacity for "CONTAINERS").

■

Fluid CIRC. 1:

 nature of fluid in circuit 1.

■

Fluid CIRC. 2:

 nature of fluid in circuit 2.

■

Voltage: 

Power supply.

■

Volume:

 Capacity of the circuit.

■

P.Abs/P.Input

: Power input.

■

P.serv.\ Working P (PS):

 Operating pressure. (Maximum allowable pressure set out in European Directive 2014/68/EU).

■

Current (+/-10%):

 Maximum current.

■

Max. temperature:

 Maximum permitted temperature.

■

Poids/Weight: 

Maximum empty weight including options and accessories.

4.1 - Designation

E.g.: 

1 10 4 UI 740 E 8A 12A1

10:

Number of fans:

4:

Number of rows of finned tubes: 3 or 4

740:

  Rotation speed (rpm)

E:

Motor type:

A  =  AC motors (3-ph/400 V/50 Hz), 

B  =  AC motors (other voltages), 

E  =  EC motors, 

X  =  ATEX motors, 

M =  1 stage with EC motors.

8A:

Motor impeller:   9A/9B/9C/9D  =  impeller Ø 910 mm,

8A/8B/8C/8D  =  impeller Ø 800 mm,

12A1:

 Type of fins: 

12A1 = Tube  Ø 12.7 mm,

16B2 = Tube  Ø 16/15.87 mm.

5