Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No.04-53300194-01
Printed in U.S.A.
Form 30-36SI
Pg 2
10-18
Replaces: New
© Carrier Corporation 2018
19XR Pumpout Units
1. Examine the package contents. Check to be sure there are
4 wheel assemblies in the carton. Spacers are included in
the carton but are not used and can be discarded. Notify
your Carrier representative if pieces are missing or if the
accessory is damaged.
2. Remove 4 lag bolts attaching the unit to the skid and dis-
card the bolts.
3. Jack up the unit to a height of approximately 6 in. above
the shipping skid and block in place. Be sure to block the
unit securely so that it cannot fall during installation of
the mobility package.
4. Mount the wheel assemblies to the unit. Mount one wheel
assembly to each of the basepan mounting holes as
shown in Fig. 3. Use the same mounting holes from
which the lag bolts were removed in Step 2. Tighten the
nut so that it holds the wheel assembly securely once the
assembly is mounted on the unit. A minimum torque of
20 ft-lb (27 N
m) is recommended.
5. Remove the shipping skid from under the unit, remove
the blocks, and carefully place unit back onto the floor.
The unit is now ready to roll to the desired location.
BOLT
WASHER
NUT
LOCK WASHER
WASHER
Fig. 2 — Mounting Wheel Assembly, 30MPA, MPE,
and MPW Units
NOTE: Non-locking wheel shown.
BASEPAN
WASHER*
NUT*
*Part of wheel assembly.
Fig. 3 — Mounting Wheel Assembly to
Pumpout Assembly Basepan, 19XR Units
