16
MAINTENANCE
FAN ASSEMBLY MAINTENANCE: —
Refer to the
following figures and instructions for removing fan assemblies
as needed for repair and service.
Fig. 28 —Fan Disassembly (009-024)
Fig. 29 —Fan Disassembly (009-024)
Fig. 28 provides an example of the unit.
1. Remove the 11 screws from the Safety Drain Tray and remove the tray along the direction of the arrows in Fig. 29.
2. Clean the tray and evaporator.
3. Use step 1 (in reverse order) to re-assemble the unit.
CAUTION
When servicing or repairing this unit, use only factory
approved service replacement parts. Refer to the rating
plate on the unit for complete unit model number, serial
number, and company address.
Any substitution of parts or controls not approved by the
factory will be at the owner’s risk and may result in
equipment damage.
CAUTION
To avoid equipment damage, do not attempt to reuse any
mechanical or electrical controllers that have been
exposed to moisture. Replace the defective controller.
CAUTION
1. Shut down the unit and cut off power performing
maintenance.
2. Before dismounting the fan assembly, disconnect all
wires between the fan and the controller.
3. The Fan sub-assembly is very heavy so be careful
while handling. Otherwise physical injury can occur.
