36
From the QR code reader
there are four wires, power
and communication to be
connected at the readers
terminal blocks.
Technical data QR code module
Note that the connected LNL-R50360-04TB (without keypad) and
LNL-R50365-04TB (with Keypad) reader must be running on Firmware
3.82.09 or higher to use the QR module as an accessory. Older firmware
versions of LNL-R50360-04TB (without keypad) and LNL-R50365-04TB
(with Keypad readers will not detect the QR code reader. Settings can
be done with LenelS2 Reader Tool LNL-R50000-tool version 6.5.0.7 or
higher.
Green wire D+/RX
White wire D-/TX
Red wire DC+
Black wire GND
Connection cable QR code module
36
From the QR code reader
there are four wires, power
and communication to be
connected at the readers
terminal blocks.
Technical data QR code module
Note that the connected LNL-R50 x (5-6) x-xxxx reader must be
running on Firmware 3.82.09 or higher to use the QR module as an
accessory. Older firmware versions of LNL-R50x (5-6) x-xxxx readers
will not detect the QR code reader. Settings can be done with LenelS2
Reader Tool LNL-R50000-tool version 6.5.0.7 or higher.
Green wire D+/RX
White wire D-/TX
Red wire DC+
Black wire GND
Connection cable QR code module
Sensor
r
esolution
640 horizontal x 480 vertical
Illumination
White LED
Aiming
None
Symbologies
QR code, micro QR and PDF417
Code 128, Code 39, Codabar, Interleaved 2 of 5, ITF-6, ITF-14
ISBN, Code 93, UCC/EAN-128, GS1 Databar, Matrix 2 of 5,
Code 11, Industrial 2 of 5, Plessey, MSI-Plessy
Resolution
>
3 mil
Typical
d
epth of
f
ield
(QR 10 mil) 35 mm to 80 mm
Symbol contrast
25% min.
Scan
a
ngel
Roll: 360°,
pitch
: ±60°,
skew
±60°
Field of
v
iew
Horizontal 42°,
v
ertical 31.5°
Operating
v
oltage
9
to
30
VDC
Power
c
onsumption
Current draw (Idle mode)
2.3 mA at 12 VDC, 1.2 mA at 24 VDC
Operating
t
emperature
-20 to +55°C
Relative humidity
5 to 95% noncondensing
Ambent
l
ight
0 to 100,000 lx