REFRIGERATED UPPER SECTION COMPONENT
IDENTIFICATION & REMOVAL INSTRUCTIONS
1.
Defrost Heater Lead Connection
4.
Defrost Heater
2.
Air Baffle
5.
Defrost Heater Retainer Bracket
3.
Upper Fin Coil
6.
Front Coil Housing Cover Bracket
REMOVAL INSTRUCTIONS:
Disconnect the power
supply before servic-
ing the cabinet.
1. Disconnect the defrost heater
leads located on the lower right-
hand side of the lamp channel –
Figure #1.
2. Remove the air diverter shown as
Figure #2. This will expose the
defrost heater rack which is mount-
ed to the evaporator fin coil. Heater
and rack assembly can now be
removed.
3. Reattach new heater to rack.
NOTE: Last pass of the defrost
heater must lay down in the drain
trough.
4. Reassemble in reverse order.
CAUTION:
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5
6
6
6
6
32
MAINTENANCE & REPAIR
Summary of Contents for 52-2038-01
