EVAPORATOR COIL REMOVAL
Disconnect the power
supply before servicing
the cabinet.
A. Raise up the counter top.
B. Remove screws along the back wall
of the sub top.
C. Remove the high air intake baffle
located on the righthand side of the
sub top.
D. Remove the cabinet lids and lid rails.
E. Remove the screws that hold the
light channel to the sub top.
F.
Pull the defrost termination bulb out
of the evaporator coil bulb well. Lift
the sub top up and out of the cabinet.
CAUTION:
1.
Defrost Termination & High Limit Control
3.
Defrost Heater Receptacle
2.
Defrost Termination Bulb Well
4.
Sub Top
G. Lift the insulation up and out of the cabinet. Do not
break. This will expose the coil housing cover. This
cover is attached by three screws, one on each
end and one at the rear on the top.
5.
Upper Coil Insulation
6.
V Baffle Insulation
7.
V Baffle Front
36
MAINTENANCE & REPAIR
Reseal bulb well and coil cover with permagum
as shown.
8.
Coil Cover
9.
V Baffle Heater
NOTE:
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5
6
6
6
6
7
7
7
7
8
8
8
8
9
9
9
9
Summary of Contents for 52-2038-01
