About Advanced Features & Operation
Page 22
REMOTE SENSORS
(Optional Accessory)
- When connected
to terminals RS+5, RS, & GND on the back of the
it will read the temperature from the Remote
Sensor and ignore the temperature sensor inside the
thermostat. The thermostat automatically recognizes
Remote Sensor is connected (setup step #13-
No
).
reading the temperature from the remote, the degree
above the room temperature blinks once a second.
thermostat,
when a
When
icon
Optional
Remote Sensor
Optional R.F. Sensor
The Override button
on the Remote
Sensor works slightly different than
the Override button on the front panel.
Each press of the ‘External’ Override
button adds 2 hours to the override
timer. If the timer was already active,
the first button press will round the
runtime to either 2:00 or 4:00.
Subsequent button presses will not wraparound as the
Override button on the thermostat does, so the 2nd or
button press will set the runtime to 4:00. The
feature has no effect on the external Override
The
wired
Remote Sensor is connected to the
up to 500’ of 20 ga. or 300’ of 18 ga.
See the Remote Sensor instructions for further details.
greater
Locked
button.
thermostat with
thermostat wire
.
OVER
RIDE
FACTORY DEFAULTS - If, for any reason it is desirable to
return all stored settings back to the factory default
settings, press the Mode button. While holding the Mode
button in, press the Down button for 2 sec. All icons will
appear. Press and hold in the Override button until
Fd
appears. This resets all factory settings.
To calibrate
room temperature,
press the Mode button once more.
At this point use the Up and Down buttons to calibrate
room temperature, if needed. Press the Mode button to
return to normal operation.
NOTE CAUTION ON PAGE 1.
OVER
RIDE
