Carrier C708 Service Manual Download

Page: 8 / 148

Introduction

Models C708/C709/C716/C717

050920

Safety

______________________________

We at Taylor Company, are committed to
manufacturing safe operating and serviceable
equipment. The many built-in safety features that
are part of all Taylor equipment are aimed at
protecting operators and trained service technicians
alike.

This manual is intended exclusively for Taylor
Company authorized service personnel.

This equipment must be properly grounded.

Failure to follow this instruction may result in serious
electrical shock.

Stationary appliances which are not

equipped with a power cord and a plug or other
device to disconnect the appliance from the power
source must have an all-pole disconnecting device
with a contact gap of at least 3 mm installed in the
external installation. Failure to follow this instruction
may result in electrocution.

These machines must be placed on a level

surface. Failure to comply may result in personal
injury or equipment damage.

DO NOT

install the unit in an area where a

water jet could be used to clean or rinse the freezer.
Failure to follow this instruction may result in serious
electrical shock.

These machines are designed to operate indoors,
under normal ambient temperatures of 70°-75°F
(21°-24°C). The machines have successfully
performed in high ambient temperatures of 104°F
(40°C) at reduced capacities.

NOISE LEVEL:

Airborne noise emission does not

exceed 78 dB(A) when measured at a distance of
1.0 meter from the surface of the machine and at a
height of 1.6 meters from the floor.

Refrigerant

______________________________

Taylor Company uses R404A refrigerant. This
refrigerant is generally considered non-toxic and
non-flammable; however, any gas under pressure is
potentially hazardous.

NEVER fill any refrigerant cylinder

completely with liquid. Filling the cylinder to
approximately 80% will allow for normal expansion.

Refrigerant liquid sprayed onto the skin may

cause serious damage to tissue. Keep eyes and skin
protected. If refrigerant burns should occur, flush
immediately with cold water. If burns are severe,
apply ice packs and contact a physician
immediately.

The Taylor Company reminds technicians

to be cautious of government laws regarding
refrigerant recovery, recycling, and reclaiming
systems. If you have any questions regarding these
laws, please contact the factory Service
Department.

WARNING:

R404A refrigerant used in conjunction

with polyolester oils is extremely moisture
absorbent. When opening a refrigeration system, the
maximum time the system is open must not exceed
15 minutes. Cap all open tubing to prevent humid air
or water from being absorbed by the oil.

If the crossed out wheeled bin symbol is

affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other
similar legislation in effect after August 13, 2005.
Therefore, it must be collected separately after its
use is completed, and cannot be disposed as
unsorted municipal waste.

The user is responsible for returning the product to
the appropriate collection facility, as specified by
your local code.

For additional information regarding applicable local
laws, please contact the municipal facility and/or
local distributor.