35
ADVANCED PROGRAMMING OPTIONS
Clearing the reset reminders
The thermostat tells you when it’s time to change the UV light in the evaporator coil
box connected to the furnace (if equipped), humidifier pad (if equipped), and
furnace filter. (See page 47 for more information.) When the reminder icons are
displayed on the screen, pressing and holding the
done
button for about three
seconds clears all reminders on the screen. This might not be the best option when
you have multiple reminders but have done only one of the tasks. This option lets
you reset the reminders individually.
1. Open the door.
2. Press and hold the
buttons underneath the heat and
cool setpoints
simultaneously (the two bottom buttons
on the right). The screen will display 01 and up to three
reset reminders, as enabled by your installer. One of the
reminders will flash; the display will show the percent-
age of time used by that reminder item.
3. Repeatedly press the
set
button until the reminder you
want to clear flashes.
4. Press and hold the
done
button for about three seconds to remove the re-
minder. The percentage associated with it will go down to zero.
Summary of Contents for Edge TP-PAC
