F97CMN and G97CMN: Installation, Start-up, Operating and Service and Maintenance Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
43
The vent elbow can be rotated to the required location on the casing if
necessary, see
. To rotate the vent elbow:
1. Loosen the clamp on the inlet of the vent elbow attached to the
inducer.
2. Rotate the vent elbow to the required position. There are rounded
notches in the vent elbow to align it with the inducer housing for
each orientation.
3. Tighten the clamp around the vent elbow. Torque the clamp to 15
lb-in, see
A14546
Fig. 50 – Near Furnace Vent Connections
A170006
Fig. 51 – Inducer Vent Elbow
(Appearance May Vary)
UPFLOW LEFT CONFIGURATION
A11309A
UPFLOW RIGHT CONFIGURATION
A11308A
UPFLOW VERTICAL VENT
A11310A
Fig. 52 – Upflow Configurations (Appearance may vary)
See “Notes for Venting Options”
DOWNFLOW LEFT CONFIGURATION
A11311A
DOWNFLOW RIGHT CONFIGURATION
A11312A
DOWNFLOW VERTICAL
A11313A
Fig. 53 – Downflow Configurations (Appearance may vary)
See “Notes for Venting Options”
Avoid short horizontal offsets with 90
deg. Elbows. Short offsets can be
difficult to slope and may trap con-
densate.
Use 45 deg. Elbows where
possible, to ensure conden-
sate drainage.
Slope vent pipe back to the
furnace at least ¼” per foot
TABS ON THE INDUCER OUTLET RESTRICTOR SNAP
INTO THE SLOTS AT THE OUTLET OF THE INDUCER
FOR USAGE:
SEE MAXIMUM EQUIVALENT VENT LENGTH TABLE
(10FT. (3.1 M) OF VENT OR LESS ONLY)
1
2
3
4
6
7
5
5
Rotate vent elbow to
required position.
Any other unused
knockout may be used
for combustion air
connection.
&
1
2
3
4
5
6
7
5
Rotate vent elbow to
required position.
Any other unused
knockout may be used
for combustion air
connection.
1
2
3
4
5
6
7
5
Any other unused
knockout may be used
for combustion air
connection.
1
2
3
4
5
6
7
5
Rotate vent elbow to
required position.
1
2
3
4
5
6
7
5
Rotate vent elbow to
required position.
Any other unused
knockout may be used
for combustion air
connection.
Requires Accessory Internal Vent Kit.
See Product Data for current kit number.