89 |
P a g e
2) Remove jumper on easy-select board.
a. Remove J1 jumper to allow for standard dehumidification control.
b. Remove J1 and J2 for applications where two stages of heating are
configured on the thermostat (W1 and W2).
3) If you want no off delay, set the blower delay to 0/0. This turns blower off
immediately at the end of each cooling cycle to prevent re-evaporation of water
on the coil.
Set to
0/0
Summary of Contents for TP-WEM01
Page 38: ...38 P a g e ...
Page 50: ...50 P a g e ...
