To set up the controller through the Service port
TruVu™ UC683T
CARRIER CORPORATION ©2021
Installation and Start-up Guide
All rights reserved
48
Ports tab
IP Port
IP Addressing
Select the type of addressing the controller is to use. See
Addressing the TV-
UC683T
(page 9).
Ethernet Port
Address
A factory assigned Ethernet MAC Address for the
Eth0
and
Eth1
ports.
Port S1
End of Network
Indicates status of the controller's
End of Net?
switch.
Protocol
Change active protocol, if needed.
Active Protocol
Indicates the active protocol on
Port S1 Configuration
.
BACnet tab
NOTE
The TV-UC683T can be configured for only one BACnet communication type.
On the
BACnet
tab, you can choose to run
BACnet Over IP
or
BACnet Over Ethernet
on the
Eth0
and
Eth1
ports.
If you choose
BACnet Over IP
, you can edit the
BACnet UDP Port
.
Modbus tab
If the controller will be used with Modbus devices, see the
Modbus Integration Guide
for information on using this
tab.
Security tab
BACnet Firewall
If your BACnet Firewall configuration in the i-Vu® interface did not include the i-
Vu® server IP address, thus blocking communication with the i-Vu® server, you
can disable the controller's BACnet Firewall on the controller setup
Security
tab.
NOTE
You can enable the BACnet Firewall only in the i-Vu® interface.
Summary of Contents for TruVu UC683T
Page 73: ......
Page 74: ...Carrier 2021 Catalog No 11 808 852 01 12 3 2021...
