About Advanced Features & Operation
Page 15
EMERGENCY HEAT - Is a feature available to Heat Pump
installations. To turn on Emergency Heat press in the
Fan button. While holding the Fan button press
Up button for 2 seconds. The Cool setpoint display
will read ‘EH’.
During Emergency Heat the thermostat will turn
on the fan and the 2nd stage of heat, when there is a
demand for heat, locking out the 1st stage compressor.
Exiting Emergency Heat is the same as entering. During
Emergency Heat only OFF and HEAT are available.
the
Press for
Emergency Heat
FAN
FACTORY DEFAULTS - If, for any reason it is desirable to
return all stored settings back to the factory default
settings, press the Mode button. While holding the Mode
button in, press the Fan button for 5 sec. All icons will
appear. Press and hold in the Fan button until
Fd
appears. This resets all factory settings.
To calibrate
room temperature,
press the up and down arrow buttons
simultaneously, twice..
At this point use the Up or Down buttons to calibrate
room temperature, if needed. Press the Mode button to
return to normal operation.
NOTE CAUTION ON PAGE 1.
74
eh
H
EAT
o
o
Am
12:00
73
:
