Box Quick release
This simple system allows fl at bottomed
hard body boxes to attach and detach
from the Y-Frame quickly and easily.
Fitting
The trailer should be positioned so the
front edge of the box runs along the front
edge of the load bed, and the box sits
centrally between the two wheels. Mark
the rough centre of the load beds four
holes. Remove the trailer and drill four
6mm holes. Bolt the location feet to the
box using the following sequence:
INSIDE Nut-washer-box-Location foot. OUTSIDE
Using
Fit the two load straps to the left and right
load bed holes. Attach one strap with its
buckle the other with its velcro. Place the
box so the four feet sit in the four load bed
holes. Secure the box with the straps
.
The straps will retain any lid on the box.
�������
��
���� ����������
������
��� ������ ����
����� ���������
���� ���� ��� ��� ��
����� � ����� ����� �����
����� ������� ����
��� ��� �� �����������
� ��� ������� ����� ����
���� ���������
��� ���� ��� ������� ���� �� �������
� �������� ���������� �� ������
���� ���������
��� ���� ��� ������� ���� ��
������� � ����� �����������
�����
��� ���� ��� ������� ���� ��
������� � ����� �����������
�������
��
���� ������� ��� �������
��
���� �� ����� ��
������ ������ �� ��� ���� ����������� ��� ���
��� �� ���������� ���� �
��
�������
Page
7
19.
Place trailer on upturned box and
mark feet locations holes
20.
Drill four 6mm holes
22.
Fit straps to the holes.
NOTE
: Attach
one strap with velcro, & one with buckle
23.
Place the four feet in the four holes
and strap the box to the trailer.
21.
Bolt the feet to the box:
IN
Bolt-Washer-Box-Foot-Nut
OUT
