21
Preparing the Trailer for Loading
Enclosed trailers may be equipped with D-ring hold-downs and/or a
track system that can be used to secure the cargo. Inspect the D-rings
and track system closely for looseness or signs of bending before
loading the cargo onto the trailer.
Do not use a damaged or loose D-ring to secure cargo.
Damaged or loose D-rings might break. If this happens,
the cargo may become loose inside the trailer and shift
the center of gravity, resulting in an out-of control trailer.
Loading the Enclosed Trailer
Some enclosed trailers are equipped with a drop ramp door. The
weight of the drop ramp door is partially held by a spring and cable
counterbalance assembly.
If the spring and cable is out of adjustment or worn out, it will not pro-
vide the expected assistance for slow and careful lowering and raising
of ramp.
A spring and cable counterbalance may inflict serious
injury if it breaks, or if it is incorrectly adjusted.
Inspect the cable and cable ends each time the door is operated. Do
not attempt to service the counterbalance. Take the trailer to your
Carry-On Trailer dealer for service.
To load your trailer:
1. Carefully lower the drop ramp to the ground.
2. Load the cargo up the drop ramp and into the trailer.
3. Secure the cargo to the trailer using appropriate straps, chains and
tensioning devices.
4. Close the drop ramp door and secure the trailer door catch, so that
the catch and the door cannot open while the trailer is being towed.
Always secure the door latch after closing. Place a linch
pin in the catch. If the door opens, your cargo may be
ejected onto the road.
Preparing to Tow
Summary of Contents for 4x6CG
